hot rodder gone rotary
#1
Hey everyone. My name is Andy im from nj, Im currently building a 1938 international pickup chopped 10 inches sectioned 12 and channeled 3. I have built my far share of small blocks big block straight 4's 6's and 8's. I finally picked up a old rx-7 with a 13b in it. So i ripped out my 302 and im mounting the 13b. it has a street beat intake with a 750 double pumper and a header. I have been reading everything i can get my hands on. And your website is amazing! I have a question for anyone that can help. the car runs but the carb was taken off before i got it (i have another one). where does the oil injection lines go? Any input would be much appreciated.
Thanks
Thanks
#2
Welcome to the wonderful world of Wankel.
Unless the carb is a modified RB unit, you can route them anywhere as long as they empty into the primaries.
I did mine like the pic. It's hard to see, but I drilled 2 holes in the top of the air cleaner and ran two nipples through them, then ran silicone vacuum lines to the original OMP lines off the engine.
Unless the carb is a modified RB unit, you can route them anywhere as long as they empty into the primaries.
I did mine like the pic. It's hard to see, but I drilled 2 holes in the top of the air cleaner and ran two nipples through them, then ran silicone vacuum lines to the original OMP lines off the engine.
Thread
Thread Starter
Forum
Replies
Last Post
Tomoya
2nd Generation Specific
8
05-23-2006 04:54 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)