i know i have to remove everything which is no big deal.....keep in mind low budget. i am not looking for mona lisa in the engine just better than the rust and three different shades of white i have now https://www.nopistons.com/forums/pub...DIR#>/wink.png
|
if u plan on doing it yourself just clean it real well with a degreaser and lightly sand the whole area...a high quality spray paint shall suit u just fine since i'm sure u aren't looking for a show car look...
|
i might go that route. i cleaned it already. gotta strip out more stuff
|
Flat black high temp paint! https://www.nopistons.com/forums/pub...IR#>/bigok.gif
Means business look. |
you cheap bastid
scrub it with some scothbrite and some comet and water, this will etch the surface as well as clean off any grease. Then go wild with some spray cans, use some primer if there are bare spots. Obviously mask the area around it and do it in a well ventilated area. |
rob this is the BEATER T2!!!
i started it. cleaned everything. went to town with spray paint looks decent. much better than before. i have to go apply another coat then paint the subframe black again |
get it rhino lined!
kevin. |
all done might do another few coats tomorrow. i'll see how it looks. engine is going back in thursday. then wiring up microtech https://www.nopistons.com/forums/pub...IR#>/smile.png
|
cool, i know its too late but i used some appliance epoxy rattle can pain on mine and that stuff will not come off, its been great
mike |
Uh, pics?
|
All times are GMT -5. The time now is 01:24 PM. |
© 2024 MH Sub I, LLC dba Internet Brands