Just picked up new rear RX7 Mazda logos for the back of my 94 fd . They seem to have some adhesive on them but I think its not enough to hold them to the body very long . Have any of you replaced yours ? They seem to be made of plastic or a urathane . Let me kbnow if you used anyhting to help hold them . Thanks

 

they have held fine on my car for 2 years now.

 

those are fine.

if the adhesive ever comes off, you can use liquid cement, or 3m double sided tapes.

 

just try to install them when they and the car are nice and warm

 

i used rubber cement back when i put on the efini logo's on my car....... dont know if i did that right, but it stayed for a good year before i used the wall on the nj parkway to scrape it off

 

OUCH.........

 

yes, exactly what i said

 

I used this stuff in the past. Most autobody / paint supply shops can order it for you.



3M™ Press-IN-Place Emblem Adhesive 08069, 2 in x 12 in, 60 per case

Transfer adhesive allowing emblems with existing foam tape to be re-attached. No stringing or triming needed. Simply press emblem onto adhesive and place emblem on vehicle. 10 pieces per pack, 6 packs per case.





3M Id : 60-9800-2841-3

GTIN(UPC/EAN) : 0 00 51135 08069 6

Buyer's Part Number : 08069



mark

 

where would you pick up rear "rx-7" badges anyways? mazda? n r they expensive, i know when i bought two more "m" badges for my last car it was around 60 for both letters.