I have a din panel that fits three gauges. It's under the radio. I'd like a little cleaner look....



So I'm going to mold it there and remove the seams. Anyone done this?

 

you know about the 3 guage saab one right?



mike

 

you can also get the guage pods that go where the center speaker vent goes. so you can actually read the gauge while driving

 

That's the one I have...





I'd like to mold it into the stereo console for a factory look. I'm sure it's been done... Similar to the AC relocation I'd imagine... I may need some advice though, as I've never worked with bondo, or any of that ****.

 

That's the one I have...





I'd like to mold it into the stereo console for a factory look. I'm sure it's been done... Similar to the AC relocation I'd imagine... I may need some advice though, as I've never worked with bondo, or any of that ****.[/quote]

Can I see a pic of the set-up?

 

That's the one I have...





I'd like to mold it into the stereo console for a factory look. I'm sure it's been done... Similar to the AC relocation I'd imagine... I may need some advice though, as I've never worked with bondo, or any of that ****.[/quote]

Can I see a pic of the set-up?[/quote]

I'll post it as soon as I get off work.

 

The trouble with this forum is that not enough people are on it.

On the other forum, too many people among other things.

But here is a thread on the other forum which describes what you are talking about.

http://www.rx7club.com/forum/showthread.ph...&threadid=88555

 

I have done it, just on my FC, I could lend the advice though if someone wanted it, or even do it for people if they sent me thier dash.

 

Dammitt... I can't load pics on NP.net...



"cannott find server"









VOSKO!!!!!!

 

i dont know about the uploading part but it seems fine to me