Rx7 Tools?
#23
safety goggles!!!!!!
they saved my eyes twice now.
one time... i was cutting something with a dremel... next thing i know something flew at me. A peice of my carbide shaping too broke off and flew into the goggles, bounced off.
that goggles cracked a bit... wow...
the other time was when i was fixing something...
i remember now.
i was helping a friend change his fuel filter. we thought all the pressure in the lines were gone and next thing iknow i get a face full of fuel. thank good ness for safety googles.
they saved my eyes twice now.
one time... i was cutting something with a dremel... next thing i know something flew at me. A peice of my carbide shaping too broke off and flew into the goggles, bounced off.
that goggles cracked a bit... wow...
the other time was when i was fixing something...
i remember now.
i was helping a friend change his fuel filter. we thought all the pressure in the lines were gone and next thing iknow i get a face full of fuel. thank good ness for safety googles.
#27
Originally Posted by Digisan' date='Jul 11 2003, 07:21 PM
Clearance gauges and plastigauge.
Dial bore gauge = real tool, only needed for building motors
stubby 3/8 drive rachet, they are about 3 inches long and its all you need when driving a bolt into aluminum
#28
Originally Posted by j9fd3s' date='Jul 11 2003, 01:53 PM
[quote name='banzaitoyota' date='Jul 11 2003, 01:50 PM'] [quote name='DJ Rotor' date='Jul 11 2003, 04:34 PM'] [quote name='banzaitoyota' date='Jul 11 2003, 01:29 PM']
Input shaft of a broken transmission(For clutch alignment)
Input shaft of a broken transmission(For clutch alignment)
http://www.mazdatrix.com/toolmisc.htm
about halfway down the page
J [/quote]
I find those plastic alignment tools to be hit or miss. I prefer to use an input shaft, that way you know it works! [/quote]
i use me eyeball matey
mike [/quote]
Mee too, just eyeballed it for the repu..
Thread
Thread Starter
Forum
Replies
Last Post
tuxracer
Rotary Engine Building, Porting & Swaps
19
05-19-2003 10:19 AM
teknics
Rotary Engine Building, Porting & Swaps
2
05-10-2003 07:54 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)