Power Fc Question
#1
Hey,
Just got an Apexi Power FC and Commander unit for my 93 RX-7 R1. I may have a problem in that my O2 sensor has been permanently disconnected (wire cut) from the car. I am assuming that the Power FC is going to need to get readings from the sensor to configure itself properly (mixture settings).
Is this a correct assumption?
If so, what can I do about it? I don’t think there is enough wire left on the sensor to splice. Where is a good place to buy a new one?
Why might this have been done? It was like this when I got the car. I can think of a much cheaper way to plug a hole in a cat if the sensor wasn’t desired.
Any help would be appreciated.
Thanx,
Kamikaze
Just got an Apexi Power FC and Commander unit for my 93 RX-7 R1. I may have a problem in that my O2 sensor has been permanently disconnected (wire cut) from the car. I am assuming that the Power FC is going to need to get readings from the sensor to configure itself properly (mixture settings).
Is this a correct assumption?
If so, what can I do about it? I don’t think there is enough wire left on the sensor to splice. Where is a good place to buy a new one?
Why might this have been done? It was like this when I got the car. I can think of a much cheaper way to plug a hole in a cat if the sensor wasn’t desired.
Any help would be appreciated.
Thanx,
Kamikaze
#3
Thanks. I thought so. Kinda new here so I am just learning about the forum. 30 secs after I posted this, I noticed the ECU discussion board. I have already reposted it there.
What about the guys that don't run with cats? I would think there must be some workaround.
I appreciate it.
What about the guys that don't run with cats? I would think there must be some workaround.
I appreciate it.
Thread
Thread Starter
Forum
Replies
Last Post
For Sale Power FC/HKS Twin Power
Rotarynerd
RX-7 & RX-8 Parts For Sale & Wanted
3
03-25-2015 02:21 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)