FikseRxSeven

so............



.96 has undivided manifold and 1.0 has divided?

remydrm

Can you explain this further for some of us slow folk.

please.

boost_creep

Whats the cost of the HKS knock off? I imagine if you are confident in its ability, then you have no problem offering replacement or repairs if it messes up.



You said the Tial 38mm is $200.00 I might go with that if instead of the HKS knock-off. I always liked how the HKS looks but the price is a little sweet for my blood right now.

9BASE3

Yes. .96 is undivided and 1.00 id divided.



I honestly can't feel the difference in the divided and undivided... But people really go crazy about the divided tang. housings..

9BASE3

We bought like 12 of the knockoffs so we got them at a very good price.. I actually don't know the price to replace them off the top of my head. I will warranty them for failure though. If they fail, send them back. I'll replace. No biggie there. The TIAL is more than 200.00, but I decided that 200 is fair to add it to the kit instead of the HKS copy. Tials arent cheap, but they are way more reasonable than some of the companies out there.. And perform equally.



I'll do what I can to keep the prices down, just remember that I can't go TOO low.. Otherwise I'll be paying you to take them from me LOL..

TheCamel

If the kit was ordered, how soon would it be available to the end user, meaning do you have it on the shelf for shipment or do the kit pieces have to be ordered and sent to you first. Also can we get a few pics and specs on the manifolds being used? I am kind of curious on the wall thickness, and if the flages for the divided and undivded will be on the manifolkd as well

9BASE3

The kits aren’t complete. We have the Manifolds, Downpipes, and wastegates.. However would order the turbos and make the lines upon request.



After ordering, the kits shouldn’t take more than 2 weeks to be delivered, however I said 30 days due to a previous shipping incident that caused a headache at the other forum.



I’ll get the pics and specs of the manifolds as soon as I get back to the shop (Full time Army, so try to bear with me) The manifolds are a copy of the Ebay manifold. We get them pre-cut but not assembled, so we can weld the flanges to fit the different turbos. Many think the manifolds are OBX and they aren’t. I’ll measure the wall thickness as soon as I can. I have YET to see any failed manifolds. As for the wastegate flanges: We weld the TIAL flange on top of the HKS flange when a TIAL gate is used in place of the HKS. Reason: the Diameter of the hole in the TIAL flange is too big for the piping and there isn’t a way to weld it to the manifold. I did this to mine and at least 2 other cars with no ill side affects. Still looks clean and the gate sits WELL above the subframe.



Normally, we don’t use dump tubes. I didn’t really notice much of a difference in sound, but some prefer it.. I’ll have to check to see what kind of effort goes into doing this.



All the manifolds are divided.

FikseRxSeven

how bout a resonated dump pipe

9BASE3

I'll get back with you. I'll need to source the 2" bends and flanges... But I'll check for ya.

Dysfnctnl85

If you put a kit like this together for the TII, I'm all over it.



I'm in the process of a 13b Cosmo swap and I want a T04R real bad!