View Poll Results: What would you get if this was your RX-7?
Motec
0
0%
Wolf3d (LMAO, or so I hear)
0
0%
Voters: 10. You may not vote on this poll
For My 800th Post, A Poll For You.
#1
For my TII with the mods in my sig, which would you go for?
My vote would be for the E6k or E11 but I'm not too thrilled about spending all that money right now, plus I'm iffy that the Haltech uses GM sensors.
Also, I dont plan on going over 10 psi and/or 300whp for a few years at least.
My vote would be for the E6k or E11 but I'm not too thrilled about spending all that money right now, plus I'm iffy that the Haltech uses GM sensors.
Also, I dont plan on going over 10 psi and/or 300whp for a few years at least.
#5
hahaha That was me.. OK, I would get an E11 cuz I want one.. But I have heard there have been tuning problems with it.. But it can run a 13bt and 20b, and OMP and it is supposed to be more precise and have boost control.... and better software.. But that is just my opinion.. I think the E6K is proven though..
OH No need for name calling..
OH No need for name calling..
#7
i think the e6k, or the bottom level motec (m4) would be good choices. the e6k does a great job on a 2 rotor/4cylinder car. the tec systems are nice too. basically vosko is right though, get the one you have the most support for
mike
mike
#10
depends how much you wanna play around with the settings.......... me personally, i would rather not play around with that, and actually am looking for a pettit unlimited ecu...... with anthonyc 's recommendations