Having issues with ECU - NoPistons -Mazda Rx7 & Rx8 Rotary Forum

ECU Discussions Area for Haltech, Power FC, MOTEC and other ECUs

Having issues with ECU

Reply

 
 
 
Old 05-29-2018, 05:26 AM
  #1  
Junior Member
Thread Starter
 
Join Date: Feb 2018
Posts: 12
Default Having issues with ECU

Hi,

I'm new to the world of hondata. I'll jump right into the issue:
Car starts and idles as normal. Up until this point had 0 issues. The afr was a little lean for idle, so while it was running I added a tiny bit of fuel on the low cam table, pressed upload, car immediately died. After it died, I started it again, tried to apply throttle and the car instantly dies. If it give it less than 5% throttle it'll rev up fine. The aem wideband reads normally, but when I am datalogging the AF doesn't change at all. It's stuck at 17.41:1. I tried erasing the ECU and uploading the original calibration with no luck. Car dies when throttle is applied. Still idles fine, a little leaner than normal. I suspect the ECU is getting the wrong AF reading and as such is not running right. I am worried I may have fried the ECU??? Sure hope not, I read on here that it's not harmful to upload while running.Car is a 96 GSR built and turbo'd, running Hondata s300 V1. Everything else seems to be functioning normal except the hondata AF reading.

Any help will be apprecited.

I didn't find the right solution from the Internet.

References:
https://www.hondata.com/forum/viewtopic.php?t=20042
Bitcoin Shopping Examples

Thank you.
HarryJenkins1 is offline  
Reply With Quote
Reply
 
 
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
NavyFD3S
3rd Generation Specific
12
12-03-2012 11:02 PM
mirandama1
ECU Discussions
1
07-21-2008 12:23 PM
yugyratorx
2nd Generation Specific
5
11-07-2007 02:29 PM
nopistons94
3rd Generation Specific
11
05-11-2007 10:13 AM
Rotaryman88
Insert BS here
7
12-03-2001 09:01 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Thread Tools
Search this Thread