Rxtasy

this is the most common board so I wanted to post here...I have installed the haltechs e6k and I bought and installed the boost solenoid and i need to talk to someone else who has installed the boost solenoid...I don't know if i have it wired up right and configured right on the computer so if anyone can offer me any help that would be great...my email is sapd_matt@hotmail.com or you can just post here and I'll get in touch with you...

AJC13B

I have it hooked up, whats the problem?

Rxtasy

i have an 88 Turbo II and I don't know whether I hooked up the boost solenoid right or not...the car runs great now that I have the haltech in, but I don't wanna get on it too hard in case it's not wired right or configured right.... the way that I wired it was one wire from the solenoid went into the +13v, and the other went into PWM output 1.... the manual didn't give any help on hooking that up, so i had to guess... I'd imagine that I have it right....and in the configuration I enabled PWM output 1 for the turbo wastegate, set period (i think) to 33, limit to 20 KPAs, and the rest of the settings I left alone i believe....I ordered a laptop and it hasn't come in yet and no one i know has one so I can't see if it's working through that way, i configured it using my home PC... we used an ohm meter to see if when REVed up it would send a send voltage through and it didn't, but I'm imaging that is because when not in gear you don't get enough mainfold air pressure to enable the wastegate... also, I'm pretty sure i hooked up the vacuum lines right too, but just in case, I have one running to the wastegate actuator, one from the intake hose right after the turbo, and I'll have to go check where i ran the last one to...back into the intake I believe...