Tuning ?
#1
I have just rectleny picked up a 1993 rx7 but need some tuning is there anyone in the philly area that can do this it has a 13b street port and a haltech system and msd ingiton
I have just put in ame wide band in
Car runs a little rough when in idel and has a hickup when starting out but after that everything good motor has about 400 miles on it
Also the pvc valve has been removed and the guy put a rubber hose loop on the oil fill is it nessrey to put the pvc valve back on and if so where would i hook it up to
I have just put in ame wide band in
Car runs a little rough when in idel and has a hickup when starting out but after that everything good motor has about 400 miles on it
Also the pvc valve has been removed and the guy put a rubber hose loop on the oil fill is it nessrey to put the pvc valve back on and if so where would i hook it up to
#2
Don't forget about the break in period! 400 miles is not enough to really nail it yet (I'm sure you know this). Shorter trips for good hot/cold action is best to get things settled.
KD Rotary is in PA. http://www.kdrotary.com/
KD Rotary is in PA. http://www.kdrotary.com/
#3
I hear from Ernie Taylor that KD rotary has blown many a motor trying to tune.
I would contact either Demetrious in Maryland or Ray Wilson of PFS also in Maryland. You can contact Demetrious here via pm. His user name is rotor dee. You can call PFS @301-874-0611 Both of those guys could get you set up and are only a few hours drive from you.
The line coming off the oil fill is just fro crank case ventilation. You can just run it into a oil catch can ( or a beer bottle like us cool guys )
I would contact either Demetrious in Maryland or Ray Wilson of PFS also in Maryland. You can contact Demetrious here via pm. His user name is rotor dee. You can call PFS @301-874-0611 Both of those guys could get you set up and are only a few hours drive from you.
The line coming off the oil fill is just fro crank case ventilation. You can just run it into a oil catch can ( or a beer bottle like us cool guys )
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)