I have just rectleny picked up a 1993 rx7 but need some tuning is there anyone in the philly area that can do this it has a 13b street port and a haltech system and msd ingiton



I have just put in ame wide band in



Car runs a little rough when in idel and has a hickup when starting out but after that everything good motor has about 400 miles on it



Also the pvc valve has been removed and the guy put a rubber hose loop on the oil fill is it nessrey to put the pvc valve back on and if so where would i hook it up to

Don't forget about the break in period! 400 miles is not enough to really nail it yet (I'm sure you know this). Shorter trips for good hot/cold action is best to get things settled.



KD Rotary is in PA. http://www.kdrotary.com/

I hear from Ernie Taylor that KD rotary has blown many a motor trying to tune.

I would contact either Demetrious in Maryland or Ray Wilson of PFS also in Maryland. You can contact Demetrious here via pm. His user name is rotor dee. You can call PFS @301-874-0611 Both of those guys could get you set up and are only a few hours drive from you.

The line coming off the oil fill is just fro crank case ventilation. You can just run it into a oil catch can ( or a beer bottle like us cool guys https://www.nopistons.com/forums/pub...IR )

Hey Dave,

Does that qualify for open container if you get pulled over??? https://www.nopistons.com/forums/pub...O_DIR#>/37.gif https://www.nopistons.com/forums/pub...DIR#>/beer.gif https://www.nopistons.com/forums/pub...DIR#>/40oz.gif https://www.nopistons.com/forums/pub...>/beerchug.gif

or kahren in the NYC/NJ/CT area, as far as tuning...he can also be PMed here under said name.