All right I have installed a shaved door handle kit witch can control up to seven functions. I have the kit wired up to close the sunroof by hooking up a 30 to 40 amp five prong relay in between the switch and the motor relay and it works fine, but when I did the same set up to the opening side it did not work. Every thing I try just blows a fuse. Any one know how I should wire this up?

 

the fuse your blowing is the 30 to 40 amp one you added on the opening side?

 

No it is the 15amp one that is going to the switch. It is acting like I am grounding it out , but I am not .

 

Never mind I found the wires that were marked wrong.