Quick question
#1
I was reading up on manual boost controllers and I just was wondering if anyone had any info on how to adjust it. I have the concept of it but I don't wanna turn it on with the boost set way to high and pop the motor or something. Thanks in advance.
#4
Originally Posted by unlucky#7' post='870587' date='May 5 2007, 06:04 PM
Typically one full turn of the screw is 1 pound. If you tighten the screw all the way you should be fine to start. Then drive it a little and adjust as needed.
I would think pending what kind of boost controller (manual).
But he is correct, you want to start off with lowest boost setting and slowly turn it up.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)