I was reading up on manual boost controllers and I just was wondering if anyone had any info on how to adjust it. I have the concept of it but I don't wanna turn it on with the boost set way to high and pop the motor or something. Thanks in advance.

Typically one full turn of the screw is 1 pound. If you tighten the screw all the way you should be fine to start. Then drive it a little and adjust as needed.

Awesome, thanks https://www.nopistons.com/forums/pub...IR#>/smile.gif



Just what I was looking for

I would think pending what kind of boost controller (manual).



But he is correct, you want to start off with lowest boost setting and slowly turn it up.

I'll be getting the VBC turbonetics MBC. I thought about doing the cheap home depot one, but I would rather spend the money to get a nice one.



Thanks for the info guys https://www.nopistons.com/forums/pub...IR#>/smile.gif