It would be a good time to replace your radiator with a larger one...unless you dont mind, re-doing stuff. I am leaning toward the airnix as well, but I have seen them and they look pretty shitty on the filter side......looks like a damn sponge. Hence the reason for this post... I would like to see if any one has made any other intakes or filters work.

 

yeah my bad bro, I was half asleep and only saw half the thread title...

 

heres another

 

I mean't this pic..

 

al where did you wind up getting the greddy elbow from ?

 

I got it from Rx7Trix

 

cool

 

Coool what filters did you use? it looks like you modified the secondary turbo intake hose to accomodate the filter.... and what did you do with the hoses that attach to the secondary turbo intake?

 

I've talked to few and seen some installs..



Nocab72 from Columbus uses Apexi intake for this set up (in the past).. I also just purchased Greddy FMIC 2 row and thinking about the intake issue..



currently I think i might try with my PFS intake filter.. i have extra filter from my previous set up.. I'll try this next weekend.. I'm going to rotary revolution this week to see what else is going on.. But Xavier from RX7 store said apexi is pretty easy to install with FMIC..



Otherwise, ALNY93R1's pic is my next choice.. My friend "SPOautos" is running similar set up on his twin turbos.. except stock mount IC..



How about the over heating issues with radiator?? I do have Fluidyne radiator.. but I'm not sure if I'm going to still have enough air flow..

 

I use the 21/2"x6" K&N's filters, for the primary I used the oem rubber hose and beleive it or not a

tomato sauce can (Goya) to make it connect. If you push it in all the way you can't see the can at all.

As for the secondary, I used the stock rubber coupler and another small can. Just get that can opener

and open both sides, peel it , wash it and it will work. As far as the water temps , I'am running

hotter than before the fmic install, but still in the safe zone.



Alex