Oil Cooler- Adapter Fitting Size?
#1
i need to know what size adapter i need to run from the 2 stock oil lines to 10 an fittings. I am ordering these adapters from mazda trix and need to know if it is a 16mm /10 or 18mm /10, or something else. here is a picture of the lines i need to tap into (show with arrows). i am not planning on removing the lines shown either.
#3
I would not **** with tapping those. Matter of fact, I don't think you can..
Just get 22 x 1.5 to -10AN adapters for the oil cooler itself, and 18 x 1.5mm to -10AN adapters for the front cover and oil pedestal. Then get 2 -10AN straight fittings, and two -10AN 90degree fittings and some -10AN stainless line.. Make 2 completely new lines. VERY easy - and sturdy.
Justin
Just get 22 x 1.5 to -10AN adapters for the oil cooler itself, and 18 x 1.5mm to -10AN adapters for the front cover and oil pedestal. Then get 2 -10AN straight fittings, and two -10AN 90degree fittings and some -10AN stainless line.. Make 2 completely new lines. VERY easy - and sturdy.
Justin
Thread
Thread Starter
Forum
Replies
Last Post
1Revvin7
RX-7 & RX-8 Parts For Sale & Wanted
1
09-26-2005 10:23 AM
turbovr6
1st Generation Specific
3
11-08-2002 05:35 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)