I would test the actuators with a vaccum pump. also to be sure disconnect the rods and see if you can manually open/close the doors.

 

i was having the same exact problem but i went back to seq and it got what i set the mbc to so i dunno what it is rikki you might know i followed your how to im guessing this guy had the same problem as me cause i got 0-1 psi with non seq but with seq got 12

 

Hey fatboy,..https://www.nopistons.com/forums/index.php?...showtopic=14733



And your problem is?

 

No, I rebuilt my engine as you may know last winter. I lost those turbos about two years ago. My best guess is that tthe blades ended up in the stock intercooler end tank. [/quote]

The point here was not the "I" rebuilt the engine all by myself. The point is that when "I" disassmbled my engine all by myself. "I" did not find the broken turbo blades in rotor housings.



It's called reading comprehension ************, try learning it.

 

No, I rebuilt my engine as you may know last winter. I lost those turbos about two years ago. My best guess is that tthe blades ended up in the stock intercooler end tank. [/quote]

The point here was not the "I" rebuilt the engine all by myself. The point is that when "I" disassmbled my engine all by myself. "I" did not find the broken turbo blades in rotor housings.



It's called reading comprehension ************, try learning it. [/quote]

Are you 2 brothers? You sure act like it!!!!

 

Chill on the name calling "Mr.bouncychecka" That will be $25.00 to the bill hahahahah

 

Dont Be A bit Bitter