How to adjust lock tension?
#2
I'm assuming you are syaing that its too hard to turn the key???
If so then you need to squirt some silicone lube in the keyhole, and if you feel like it take the door panel off and spray all the linkages.
There is no way to adjust the tension.
If on the otherhand, something is moving too freely, then either a bushing is worn or broken, or something needs to be tightened
Jay
If so then you need to squirt some silicone lube in the keyhole, and if you feel like it take the door panel off and spray all the linkages.
There is no way to adjust the tension.
If on the otherhand, something is moving too freely, then either a bushing is worn or broken, or something needs to be tightened
Jay
#3
well it's the tension in the lock on the inside, like pushing and pulling the little handle for the door lock. I remember when they were installing my alarm they were adjusting something that controlled how hard it was to unlock and lock the door from the inside. I thought it was a screw or something like that. Thanks for the response jay.
#5
Ok since you had an alarm put in I'm assuming they put an actuator in th door so you can lock/unlock the doors with the remote. The FD stock has no power lock on the drivers side, you have to add one for an alarm. So that being said I don't recall those solinoids having an adjustment for tension, the bracket it mounts to may have an adjustment. If it's getting really hard to move the lever then that soilinoid may be going bad.
#6
ohhh okay thanks a lot! i'll probably take it to a stereo shop and have them take a look at it. I had the alarm taken out over the summer and want to get it put back in... again thanks a lot for the help
Thread
Thread Starter
Forum
Replies
Last Post
herblenny
3rd Generation Specific
6
06-27-2006 12:27 PM
Rx7aholic
3rd Generation Specific
5
08-11-2003 08:55 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)