Fd3s/ Cosmo 13b/fc3s
#1
The engine is cosmo front, middle plate with FD rotor housings and rear plate. With zenki Fc rotors (8.5) Fd e-shaft, bearings and front cover. The cosmo intake manifolds with FD throttle body. The engine has not started yet, but should with in a week or so. Turbine is t04r(63 trim with 96 a/r) with hks gt wastegate, F-con V pro. Not sure what problems if any we will run into, nobody has really tried this before here. Will update as we go along
#8
where the throttle body meets the cosmo manifold there is section that is open below the throttle body. If you line then up together and look on the bottom you will see it. I will try to take a picture, easier than try to explain it.
Thread
Thread Starter
Forum
Replies
Last Post
RageX^NZ
Rotary Engine Building, Porting & Swaps
22
06-20-2004 01:40 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)