Anyone else here have a blitz air intake?



I just got them and tried to install them. Ran into a few problems:

1 - There is a 5th small hose that used to go to the side of the stock air box.

The blitz filters only have connectors for 4 small hoses.

2 - One of the big hoses that feed the primary turbo is too close to one of the

belts driven by the engine and rubs on occassion (when i rev).



Any suggestions on what to do?

I'm still new at this stuff.

thanks



-Mike

 

hey man i just won one off of ebay like a month ago



ok the first thing from what i rem when i put mine in everthing fit fine i had all the ports taken

and for the rubbing my filters rub a little on each other but not on my belt i should not rub i whould try to move it around and get more slack on maybe use a tie rap to move it out the way but that is kind of getto is you post a pic of the problem i can try and help you more.

 

here's a ghetto pick

 

your mystery hose is a pretty easy one. Look at the other end of it on the stock air box. It's just a vent. No idea on the rubbing though.



Travis

 

Yeah don't worry about the vent hose it's non-op once you aren't using the stock box. Huh..huh,huh...I said hose and box in the same sentance...huh,huh.

 

I have the blitz intake as well....

The belt that rubs is the airpump belt when you give the car some gas. Now that I have a torque brace to limit engine movement, it isn't an issue. Before I got that though, I would tie a strap of wire around the lower intake hose and wrap it around the metal clip on the side of the car near the fender-lining (in front of the shock tower). The best thing to do is to is to attach the intake hose so that it is slanted but still secure or just remove the airpump

 

man thats a damn good pic yeah i had that same hose not going anywere i took off the air box and that thing was just floating there if it went somewere i sure dont know were. and i dont think mine rub i dont know why your does? but im going to check mine again and make sure it dont rub.

 

i already have a torque brace....

the belt doesn't rub all the time

but it does on occassion

i already tried securing the hoses away from the belt with a wire but it's really ghetto

i'm goin to take another look at it tonight



thanks guys