Well i have to T04E and i'm looking at runnin more boost i also have a PowerFC which i would like to get the datalogit for. So i wanted to either get 1300 or 1600 CC secondary injectors. I wanted to know which ones you guy's would get i'm planing on runnin no more than 17 psi of boost. Also if you coudl tell me where i can get step my step instructions on how to put em in that woudl be great. The only other thing is shoudl i upgrade my primary ones too?



Thanks for all the help.

 

Opps will one of the mods move this please i ment to post in in 3'rd gen my bad.

 

17 psi is out of the effeciency range of a t-04E...why would you want to boost that with a small turbo?

 

I just know that the max i can boost is 17 psi due to my sensors i'm only norm goin to do 15 psi.

 

stick to 15psi or get a bigger turbo.. no use in blowing hot air...

 

I have a FMIC so there's no hot air goin into my engine.

 

since 17psi is out of that turbos efficiency rating, if you run 17psi the turbo starts to be inefficient and heats up the air it forces into the engine...



Cool air = good.

 

Yea i know it starts to heat air too much but the FMIC will help keep it cool even at high boost. Like a said i dont plan on running more than 15 ever anyway. But that wasent my question any way my question was what size injectors to use and how to install them.

 

I have the to4e. I run 1600's. plenty of fuel.



but the rail/injector combo kit from sportcar motion.

as far as the install it's not that hard, you basically take out the one rail and put in the other. But you do need a datalogit to program the PFC to run them correctly

 

Now i can use the datalogit with out a commander right. It just plugs into the commander port on the PFC and the other end goes into my laptop. I dont want to have to go but a commander if i dont have to. My laptop sits around my house doing nothing allday any way so i think it would be cool to just permently attach it to my car