Oh and the intake elbow i suppose too. Derrhhh https://www.nopistons.com/forums/pub...IR#>/wacko.png

I didnt read through this to see if it was discussed but what about the TPS?? Do i need the one of the cosmo. Will it be on the throttle body?

What the **** do i do to adjust the TPS? I never have even looked twice at it.

Hey Fd3boost, I'm currently doing this mod....if u need some help PM me. I know where u can probably get a 20B throttle body. I'll PM u the number tommorrow.

Thanks,I currently have a repu project I am buying parts for so I would rather buy them all at once as opposed to pieceing the stuff all together.

Thanks for any links or info.

sorry to bring this up again since i've heard of a few spacer/adapter kits from 6port to 4 port so......will this intake manifold both upper and lower fit earlier 13b's?

The manifold only fits 13B-re or 13B-rew. I'm sure you can just slap into your 1st Gen a 13B-re engine and call it good

Davi-locks,



You'll need to use the one on the 20B throttle body. You'll need to swap 2 pins on it so that it will work on your FD though. I used the Power FC to adjust my TPS(read the voltage off of the commander).



Be warned though, the only problem you will have is the INJECTORS. You WILL NEED to have either 850cc injectors OR a stand alone ECU and run secondary injector size of your choice.

So then find me the parts homey https://www.nopistons.com/forums/pub...IR#>/smile.png

I'd like the manifolds and gaskets as well

Any of you guy still looking for the stuff for the swap? I just got a Cosmo that died due to low compression. I can pull all **** you need, just PM me.