You know, sometimes I think my head is a question mark
#12
Sounds good, the car isnt gonna b tossed into the races or anything like that. Its just to get the car to move around a bit until I can make the trip to missouri and pick up the TII rear end and driveshaft. By the Way does anyone know what the split air pipe actually does? Do I need it? and if not, how do I cap it off?
#13
People all of a sudden think the N/A drivetrain can't hold up to a few 300rwhp launches at 8k rpm's. Of course not, it was not built for that.
Anyways, good luck on your swap, and make it look clean.
Anyways, good luck on your swap, and make it look clean.
#14
Yea the tranny is not so much my problem, but the harnesses......I dont know how to take the wiper portion and put it onto my jdm harness. The wires seem to run every which way for the wipers. So if n e one would possibly have a diagram or just tell me what wires to look for, that would be great :-)
#15
Originally Posted by rowtareh' post='789619' date='Dec 23 2005, 06:40 PM
People all of a sudden think the N/A drivetrain can't hold up to a few 300rwhp launches at 8k rpm's. Of course not, it was not built for that.
Anyways, good luck on your swap, and make it look clean.
i dunno about that, but everything else shouldnt be a problem
#16
Originally Posted by SpinningFit' post='789632' date='Dec 23 2005, 10:20 PM
Yea the tranny is not so much my problem, but the harnesses......I dont know how to take the wiper portion and put it onto my jdm harness. The wires seem to run every which way for the wipers. So if n e one would possibly have a diagram or just tell me what wires to look for, that would be great :-)
Oh yah. make sure your jdm is S5 or you will have balance issues with the N/A S5 flywheel.
Thread
Thread Starter
Forum
Replies
Last Post
rx7fcfc
2nd Generation Specific
1
05-31-2010 11:02 PM
tripod
Rotary Engine Building, Porting & Swaps
3
11-14-2009 02:00 PM
rx-7foreva86
2nd Generation Specific
0
12-21-2003 05:53 PM
Dramon_Killer
2nd Generation Specific
14
12-17-2003 10:35 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)