I have wired open the both actuator on my n/a and I want to know what it does really ???



Should I gain power on low rpm ar at high ??? I'm not sure what it does really

 

High rpm is where the power gain might be felt, you may have lost some low end, not that there was any to begin with, lol If they were working right to begin with, you probably didnt feel a difference anyhow

 

no the actuator didn't work. that why I wiring it open .. but I see the lost of power on the low end but not sure to see the difference at high... should i do somthing other than pull this open.. ???

 

You will see a loss in the low end, havent done it personally, but if it wasnt working to begin with you should see a difference in the upper rpm range, so did you see any difference??

 

no ... that's why i'm a bit confused...



I'm not sure if do the right thing.. do you know a place who explain this ???

 

above 5000 rpms it makes a diff

 

What's telling you that they were not opening before? They only open while driving under enough load. If you noticed a low end difference after wiring them, you sure wired them right. And it probably means they were working at high RPM.

 

i'm sure they not work because the vaccum line was broken.

 

yea they were prob working since he noticed low end loss but no diff at higher spds.

 

Then if you floored the pedal you should have seen a difference over 4500 RPM.