Rebuilding Engine
#11
Originally Posted by 1Revvin7' date='Mar 26 2004, 06:01 PM
When doing a rebuild if all the hard parts are good, I usually replace all the springs, and apex seals. Then upgrade to fd corner seal springs, webber 200 jets, and fd oil pressure reg. I check to see if the side seals and corner seals are within spec, and ofcourse clearance everything. Cleaning up the ports is a must also. I have used the high temp engine paint for the rotors in the past with good results.
#12
So how do I take off the oil lines going to the engine? I got the front loose, but i still does not come out. I have also took out all the ac stuff. weh, that is alot of stuff. I am going to get the braided lines for the oil nozzles from that place too. They look nice.
Thread
Thread Starter
Forum
Replies
Last Post
1Revvin7
Rotary Engine Building, Porting & Swaps
24
08-11-2003 08:16 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)