quick question - NoPistons -Mazda Rx7 & Rx8 Rotary Forum

2nd Generation Specific 1986-1992 Discussion

quick question

Reply

 
 
 
Old 06-10-2006, 09:39 PM
  #1  
Senior Member
Thread Starter
 
Join Date: May 2004
Location: Coon Rapids, MN
Posts: 310
Default

So mazdatrix has listed an upper and lower shifter bushing, and a grrove bushing for s5 transmissions. I took apart my shifter from the top and couldnt really see where the stock ones were. If I buy these are they a simple install? Do I need both of them? thanks.



Matt
spooliNrx7 is offline  
Reply With Quote
Old 06-10-2006, 11:54 PM
  #2  
Senior Member
 
Join Date: May 2003
Location: watertown wisconsin
Posts: 1,331
Default

they are easy to install, the lower one slips under the locating pin in the tail stock where the shifter slips into place, dont forget about the thrust washer that goes under the lower cup, then remove your shifter boot/seal and slide the upper one on with the pin location facing in the proper direction and slide your boot/seal back on and install your shifter.



and mainly the lower one takes the abuse but id replace both while your there
fc3sboy1 is offline  
Reply With Quote
Reply
 
 
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
rxseven
2nd Generation Specific
11
09-01-2002 10:20 PM
The Blue Bomber
2nd Generation Specific
13
05-24-2002 04:44 PM
sleeperRX7
2nd Generation Specific
12
04-10-2002 10:45 PM
Rotaryman88
Insert BS here
0
08-25-2001 11:08 PM
RXCrazy
Insert BS here
2
07-26-2001 09:57 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Thread Tools
Search this Thread