need help ><
#1
so i just did a clutch job and replace the pulsation damper. Put everything back on and now the car wont fire up. The engine cranks but the fuel pump doesnt seem to turn on and there are no sparks from the plug wires themselves. I had a tip saying that i need to check the grounds. But i have no idea where to start and what to check really. The lights and radio, etc. work but im just at a loss of electricity somewhere....help?
its a 1986 na rx7
its a 1986 na rx7
#2
Well since so much was apart triple check every little thing. Make sure you didnt swap the fuel lines around. theres a ground from the bell housing of the trans to the firewall and a couple under the manifolds. Just take your time and really look everything over.
Thread
Thread Starter
Forum
Replies
Last Post
rotors_motor
2nd Generation Specific
8
07-02-2011 02:54 AM
2Lucky2tha7
Performance Mods
2
02-12-2004 09:34 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)