What is this suppose to go to?

 

it goes on the top of the engine, there is a little cover it goes on there. it doesnt really matter as long as its grounded



mike

 

Ok thanks :bigthumg:

 

Where excactly is that cap and whats it look like?

 

I believe it goes on the bolt that holds on the inspection cover on the back of the motor, the one you remove to inspect the flywheel/clutch/pressure plate...





it's the kinda brownish / surface rusted sheet metal piece on top of the engine near the oil filter, the bolt that holds it on:

 

i thought that was for starter kill...with the factory alarm

 

no, thats part of the ignition circuit, it's called the 'condensor'.

It goes from leading coil w/ignitor to ground.



check out E.G.I. & Emission Control & Ignition system wiring diagram

 

yes it just has to be grounded, the cover deal is an inspection plate for the the flywheel and the rear main oil seal. IS there anything inside the little plastic case on the wire though?

 

actually that starter plate is also where they used to put the starters in the rx2's and 3's, they just never got rid of it



mike

 

just full of info aren't ya mike.