Gas Door!
#12
I figured it out. I went back at it last night and it turned out i simply wasnt pulling the lever far enough. I had to pull it at a 90 degree angle before it would open.
I'm surprised it didnt break. Before i was pulling until it felt like it was going to snap off but i decided to keep pulling and pulled even harder and the door finally popped open. Still, it feels like the mechanism needs to be calibrated perhaps.
I'm surprised it didnt break. Before i was pulling until it felt like it was going to snap off but i decided to keep pulling and pulled even harder and the door finally popped open. Still, it feels like the mechanism needs to be calibrated perhaps.
#13
Originally Posted by Dramon_Killer' date='Nov 25 2003, 10:33 AM
I figured it out. I went back at it last night and it turned out i simply wasnt pulling the lever far enough. I had to pull it at a 90 degree angle before it would open.
I'm surprised it didnt break. Before i was pulling until it felt like it was going to snap off but i decided to keep pulling and pulled even harder and the door finally popped open. Still, it feels like the mechanism needs to be calibrated perhaps.
I'm surprised it didnt break. Before i was pulling until it felt like it was going to snap off but i decided to keep pulling and pulled even harder and the door finally popped open. Still, it feels like the mechanism needs to be calibrated perhaps.
#17
just a warning I broke the trunk release cable on my other vert by
pulling up on it hard.
Take the plastic plunger apart and sand it down a bit, it tends to
get fucked up over time, then lube it up good with anti-seize
or even a bit of wheel bearing grease, you can even use some
vasoline if you dont have any of the other lubes.
Then put it back together and bend the little springy thing out
a bit so it releases the door better when the cable is pulled.
pulling up on it hard.
Take the plastic plunger apart and sand it down a bit, it tends to
get fucked up over time, then lube it up good with anti-seize
or even a bit of wheel bearing grease, you can even use some
vasoline if you dont have any of the other lubes.
Then put it back together and bend the little springy thing out
a bit so it releases the door better when the cable is pulled.
Thread
Thread Starter
Forum
Replies
Last Post
Rx-7blazin
RX-7 & RX-8 Parts For Sale & Wanted
0
07-17-2003 03:17 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)