OK heres whats up, my fuel injectors refuse to seat properly and actualy seal even with new o-ring and grommets. the seats look perfectly fine but I cannot get them to seal at all. Any ideas? I got the o-rings and grommets from Mazdatrix.
Anyone want a 10th anny for $5k? |
i sorta had the same prob, i have an s5 motor and the fuel rail is steel i actually had to bend it a little, to get a good seal, if you have an s4 motor your fuel rails are cast.
|
old o-rings successfully removed?
using wrong bolts in fuel rail? |
every thing is down tight and new seals are in place properly. The injectors were previously cleaned and flow tested.
|
do you have that spacer in there?
|
mazdatrix.com has the spacer that you need
|
Sure you are using the rigth orings? S4 orings are different than S5 orings ebcause the S4 and S5 injectors have different size pintle caps
|
That could be it, I did notice that the orings wern't as snug as I would have thought they should be.
Yes I have the spacer, I'm not a n00b here guys. https://www.nopistons.com/forums/pub...IR#>/smile.png Anyone know the size o-ring I need?, since I dont really feel like paying $2 an oring from Mazdatrix and waiting for them to come in. |
|
And actualy the parts Fiche has the same part number for both series. Well faack...
I had someone suggest using motor oil to soak the rubber in so that it will seal better, guna give that a go while trying uber hard to get them to sit down just so. |
All times are GMT -5. The time now is 06:46 PM. |
© 2024 MH Sub I, LLC dba Internet Brands