im installing my jacobs ignition FC1000. theres are 2 wires that form a magnetic pickup connector. A Pos. and a Neg. wire...



there are 3 wires coming from the bottom of the leading coil. red, black, and a tan kinda yellow one. (see pics)



the red and tan go to the connector. and the black is loose.



where should i connect my Pos. and Neg. wire for the magnetic pick up wires? or should they be somewhere else like the Crank angle sensor???

 

Ohh man ur gonna love this:

http://www.rotaryheads.com/modifications/FC1000/



I have one on the way, it shuld be here on wed.



Im guessing the information you need will be stated in the link, let me know if you run into any problems with those directions.. i'd prefer the heads up when I do my install.. haha

 

thats a pretty damn good writeup.....but it dosnt mention the purple and green wires. wich is the Pos. and Neg. i was talking about. lol...



i guess there not needed?

 

From what I know, the bigger red and black obviously go to the battery (pos&neg). Then the smaller red and green wires are the input to the FC100 and the white and black are the output to the coil. It says to just tuck the other wires away because u wont need them... and unless i think of something creative or decide to try and be a good guesser, im not gonna use em either. lmao

 

yeah...ijust finished hooking it up the way the write up says. havnt started it yet....



i'll let you know how it goes.

 

its beautiful...i love it



car never started so quickly.and idled soooo smooth. RPM's climb without hesitation at all!!!



and my car has a poor tune...for now