2nd Generation Specific 1986-1992 Discussion

Constant Battery Power Required For New Stereo

Old Feb 27, 2005 | 08:27 PM
  #1  
Go Flyers's Avatar
Thread Starter
Junior Member
 
Joined: Jan 2005
Posts: 4
Default

I purchased a new stereo to replace the previous Alpine unit that was originally in the car. Everything appears correct in that the other owner rewired around the amps, but for some reason I can not find a wire for a constant voltage source from the battery. To make things difficult the other owner decided to cut the wiring harness.

I have no problem finding the other wire that switches the 12v from the ignition.



I have three wires left over that neither have a constant 12 volts or that I can identify:

Blue/Yellow

Red/Black

Blue/Red



It does not appear that any wires have been cut, so does anybody have any suggestions as to what is wrong.



If I have to run another 12volt wire where is the easiest location to feed off of?



88 Vert
Old Feb 28, 2005 | 01:37 AM
  #2  
Seppuku's Avatar
Senior Member
 
Joined: Mar 2002
Posts: 2,723
From: Ky
Default

I just rewired my vert and i cant recall the color of the constant, if its not there then not sure but there might be a source in the fuse block you can draw power from look and see.
Old Feb 28, 2005 | 09:18 AM
  #3  
extremefc3s's Avatar
Senior Member
 
Joined: Jan 2005
Posts: 118
From: Hobart Indiana
Default

grab yourself a test light ground it and test al the wires wile the cars not on if all else fails run hot from battery or ignition harness
Old Feb 28, 2005 | 09:42 AM
  #4  
phinsup's Avatar
Administrator
 
Joined: Jul 2001
Posts: 24,416
From: Stuart, FL
Default

Run to the battery or grab a multi-meter
Old Feb 28, 2005 | 08:51 PM
  #5  
Rob x-7's Avatar
Super Moderator
 
Joined: Feb 2002
Posts: 12,288
From: Amityville, New York
Default

if you cant find constant power your fuse is blown, check if the lighter, horn and interior light are working, I believe one or all are on the same cicuit.
Old Feb 28, 2005 | 09:53 PM
  #6  
teknics's Avatar
Senior Member
 
Joined: Dec 2002
Posts: 4,837
From: Wayne, NJ
Default

i dont know if the constant 12v would be on the room fuse circuit, its only 7.5A...but i would check that room fuse anyway that bastard likes to blow.



kevin.
Old Mar 1, 2005 | 03:20 PM
  #7  
nightwolf_4_98's Avatar
Senior Member
 
Joined: Mar 2004
Posts: 772
From: Creighton Nebraska
Default

what i did with my buddy's honda when i couldnt figure out the wireing was this



[attachment=28906:attachment]



i put the constant and ignition together to the battery and flushed in a kill switch for the power, and it works great.. the wireing was a mess and i couldnt find the ignition wire even when i owned it and i had three decks in there.. this is by far the best thing i came up with
Old Mar 1, 2005 | 03:26 PM
  #8  
Rob x-7's Avatar
Super Moderator
 
Joined: Feb 2002
Posts: 12,288
From: Amityville, New York
Default

its not that hard to find a power lead, alot of people blow the fuses when poking around with the wiring so they cant find it.



there is no need for switches and running wires to the battery
Old Mar 1, 2005 | 04:53 PM
  #9  
teknics's Avatar
Senior Member
 
Joined: Dec 2002
Posts: 4,837
From: Wayne, NJ
Default

yea, you just need patience and a test light.



kevin.
Old Mar 1, 2005 | 08:29 PM
  #10  
nightwolf_4_98's Avatar
Senior Member
 
Joined: Mar 2004
Posts: 772
From: Creighton Nebraska
Default

belive me, i looked for the wire, i spent 2 1/2 hour's lookin for it, but never found it, i went over each wire at least 20 time's, so i just decided to go that route, it works, and it looked good in his car im not sayin there's any need if you can find the wire, i was just showin what i did when i couldnt find it.. just giveing people some helpful idea's
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
tobiasfox87
2nd Generation Specific
3
Jul 17, 2011 07:24 PM
sen2two
2nd Generation Specific
7
Apr 17, 2008 10:31 PM
pvillknight7
Rotary Engine Building, Porting & Swaps
10
Sep 7, 2006 09:52 PM
Volksjager
2nd Generation Specific
4
May 21, 2006 08:12 PM
Skylinecar1982
3rd Generation Specific
24
Feb 20, 2004 11:27 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Thread Tools
Search this Thread

All times are GMT -5. The time now is 03:56 PM.