I'm stuck here at work, and right before I left home, I went outside and sat in the car and pushed down on the clutch pedal...well, it just fell to floor. I mean, it felt as though the master cylinder worked, as it had the "feel" of it...but there was no pressure at all...and I know I put the motor/clutch/flywheel on right...everything fits. My question is...why would it not be forcing the fork/TO bearing onto the clutch? Why no pressure...did I maybe leak some fluid, etc???

 

bleed it

 

I never disconnected the master cylinder, etc or the lines...would it still need to be bled? its been a long week...sorry for the dumb ?s...

 

its possible either the master slave or hose took a crap on you



mike

 

That wouldn't suprise me...I'm actually leading to that idea...I never replaced the line...I'll probably just get an SS one and be done with it...I just wanna know its not my input shaft on the tranny or my clutch itself, ya know? I've been soo busy lately and working on the car off and on so much I don't remember if I've done everything....AAAAAAAAAAA

 

uh ohhhhh spagettio's! :yum: