clutch problem
#12
Ok, I just got done with the master cylinder. I had already done the slave cylinder, pressed the pedal in, cranked the starter in gear, car lurched. So I finished installing and bleeding the master tonight. Put the car in gear, push clutch in, crank starter, and the car still lurched.
What am I doing wrong? I'm pretty sure that if the clutch itself wore out, it would be gradual, right? This was sudden, like one shift was fine, then stopped working. So I'm still hoping it's not the clutch itself, or anyting that's expensive and involves removing the tranny.
What am I doing wrong? I'm pretty sure that if the clutch itself wore out, it would be gradual, right? This was sudden, like one shift was fine, then stopped working. So I'm still hoping it's not the clutch itself, or anyting that's expensive and involves removing the tranny.
#16
Originally Posted by BigTurbo74' post='780235' date='Nov 21 2005, 03:06 AM
can you see the piston on the slave pivot the clutch fork? if so the problem lies within the bellhousing.
#17
Took the slack out of the pedal, and it acted weird. I would start it in first, it would lurch. Then I'd try again, it would start and idle in first, but if I tried shifting into neutral then any other gear, it would grind. I guess I have to remove the tranny no matter what at this point. Any idea what I should be looking for when I do this?
#18
I removed the transmission. I think I found my problem. The bearing in the bellhousing that the fork pushes (is that the throw out bearing?), it has 2 tabs on it that look like they should hook around the ends of the fork. One tab is gone, broken off. I'd post pics but my cam went dead.
When I lowered the tranny, oil started coming out of the end where the driveshaft came out of. Is this ok? (assuming I put oil back in it) I wasn't sure if there was supposed to be some kind of seal or something there.
When I lowered the tranny, oil started coming out of the end where the driveshaft came out of. Is this ok? (assuming I put oil back in it) I wasn't sure if there was supposed to be some kind of seal or something there.
#20
Awesome. Isn't it nice to know what's wrong? Hopefully the dealership is open tomorrow (since I have the day off), and hopefully they have the TOB in stock. I guess the hard part will be getting the tranny back up there by myself.
Thread
Thread Starter
Forum
Replies
Last Post
Tazzman69
RX-7 & RX-8 Parts For Sale & Wanted
3
07-19-2009 06:50 PM
arkadyzv
RX-7 & RX-8 Parts For Sale & Wanted
1
03-23-2007 03:43 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)