changed my clutch and now my gauge dosn't work
#1
ok i had my clutch changed and now my oil pressure gauge doesn't work it goes right up to the top with out even starting the engine as soon as i turn the key it goes all the way up what should i do and how can i fix it?
#2
Senior Member
Join Date: Mar 2003
Location: Disclaimer: posts made after 11AM are most likely alcohol induced. Please disregard unless very funn
Posts: 2,436
my guess would be that someone pulled the connector to the oil pressure sender loose while messing with the slave cylinder. Check for a dangling\disconnected wire on the top rear of the driver's side of the engine.
#3
Yup. Been there, done that before.
On the driver's side, rear iron, there is a cylinder sticking out the side. It has a little terminal on the top. There's a wire with a flat connector that slides on over the terminal - it's orange and yellow IIRC, or at least has one of those colors. It should be dangling freely in that area, with a white clip on the end of it.
Slide that back over the sensor, and things should work normally again.
-=Russ=-
On the driver's side, rear iron, there is a cylinder sticking out the side. It has a little terminal on the top. There's a wire with a flat connector that slides on over the terminal - it's orange and yellow IIRC, or at least has one of those colors. It should be dangling freely in that area, with a white clip on the end of it.
Slide that back over the sensor, and things should work normally again.
-=Russ=-
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)