Who Makes Aftermarket E-shafts
01-05-2003, 12:18 PM
#3
Senior Member
Join Date: Sep 2002
Posts: 1,089
Jeff bruce in Aus makes shafts for 13B, 20B, and custom shafts for 3 rotor w/13B parts. abel and siguel both run low 7 sec 1/4 mi times with these aftermarket shafts. these were what cured abel's breakage problems, and ultimately the reason hel put the 3 rotor back in his car.
this is jeff's contact info taken from hitman's site....
Engine Designer
The engine originated from New Zealand and was designed by Jeff Bruce from Precision Engineering. If you wish to purchase the parts required to build a similar project, in either 3 or 4 rotor , you can contact him by any of the following methods.
Email : precisin@ihug.co.nz
ICQ UIN: 15067117
Phone : +64 9 415 3264
Fax : +64 9 415 3265
this is jeff's contact info taken from hitman's site....
Engine Designer
The engine originated from New Zealand and was designed by Jeff Bruce from Precision Engineering. If you wish to purchase the parts required to build a similar project, in either 3 or 4 rotor , you can contact him by any of the following methods.
Email : precisin@ihug.co.nz
ICQ UIN: 15067117
Phone : +64 9 415 3264
Fax : +64 9 415 3265
01-05-2003, 10:17 PM
#5
Senior Member
Join Date: Sep 2002
Posts: 1,089
Originally Posted by Grizzly' date='Jan 5 2003, 01:18 PM
Triple or 20B? there is a Diffrence.
01-07-2003, 08:10 AM
#10
Senior Member
Join Date: Sep 2002
Posts: 1,089
Originally Posted by rotarychainsaw' date='Jan 6 2003, 04:47 PM
thats impressive.
all you need is a 20psi boost spike on a T04 powered TII with nothing but an fcon for fuel mgmt...