Any of them have websites?

That place Guru makes some. twist has posted some stuff about Guru.

Jeff bruce in Aus makes shafts for 13B, 20B, and custom shafts for 3 rotor w/13B parts. abel and siguel both run low 7 sec 1/4 mi times with these aftermarket shafts. these were what cured abel's breakage problems, and ultimately the reason hel put the 3 rotor back in his car.



this is jeff's contact info taken from hitman's site....



Engine Designer

The engine originated from New Zealand and was designed by Jeff Bruce from Precision Engineering. If you wish to purchase the parts required to build a similar project, in either 3 or 4 rotor , you can contact him by any of the following methods.



Email : precisin@ihug.co.nz

ICQ UIN: 15067117

Phone : +64 9 415 3264

Fax : +64 9 415 3265

Triple or 20B? there is a Diffrence.

if you were reffering to my post, jeff bruce makes shafts that are direct replacements for 20B units, and he also makes shafts for ppl wanting to build 3 rotor 13B motors....

i thought abel is still breaking engines ??? atleast that is what i have seen

he may be blowing motors, but i dont think he is snapping shafts anymore...

i think he is breaking side housings

thats impressive.

actually its not all that impressive, i've broken more than a few side housings in my day.. https://www.nopistons.com/forums/pub...#>/biggrin.png

all you need is a 20psi boost spike on a T04 powered TII with nothing but an fcon for fuel mgmt...https://www.nopistons.com/forums/pub...IR#>/smile.png j/k