Any of them have websites?
|
That place Guru makes some. twist has posted some stuff about Guru.
|
Jeff bruce in Aus makes shafts for 13B, 20B, and custom shafts for 3 rotor w/13B parts. abel and siguel both run low 7 sec 1/4 mi times with these aftermarket shafts. these were what cured abel's breakage problems, and ultimately the reason hel put the 3 rotor back in his car.
this is jeff's contact info taken from hitman's site.... Engine Designer The engine originated from New Zealand and was designed by Jeff Bruce from Precision Engineering. If you wish to purchase the parts required to build a similar project, in either 3 or 4 rotor , you can contact him by any of the following methods. Email : precisin@ihug.co.nz ICQ UIN: 15067117 Phone : +64 9 415 3264 Fax : +64 9 415 3265 |
Triple or 20B? there is a Diffrence.
|
Originally Posted by Grizzly' date='Jan 5 2003, 01:18 PM
Triple or 20B? there is a Diffrence.
|
i thought abel is still breaking engines ??? atleast that is what i have seen
|
he may be blowing motors, but i dont think he is snapping shafts anymore...
|
i think he is breaking side housings
|
thats impressive.
|
Originally Posted by rotarychainsaw' date='Jan 6 2003, 04:47 PM
thats impressive.
all you need is a 20psi boost spike on a T04 powered TII with nothing but an fcon for fuel mgmt...https://www.nopistons.com/forums/pub...IR#>/smile.png j/k |
Originally Posted by SPEED_NYC' date='Jan 7 2003, 06:10 AM
actually its not all that impressive, i've broken more than a few side housings in my day.. https://www.nopistons.com/forums/pub...#>/biggrin.png
all you need is a 20psi boost spike on a T04 powered TII with nothing but an fcon for fuel mgmt...https://www.nopistons.com/forums/pub...IR#>/smile.png j/k |
I for one think it's pretty impressive he's breaking side housings. Most guys who have borken side housings... it was due to poor tuning or a bad thing (ie: boost spike) happening, but with Abel.. they are breaking from the sheer power and boost levels he is running that engine at.
|
the hot rod shop i use to do my welding knows abel, and they are impressed
mike |
All times are GMT -5. The time now is 01:10 AM. |
© 2024 MH Sub I, LLC dba Internet Brands