Swapping In 2d Gen 6-port To Gsl-se
#1
I'm thinking I'd like to swap in a good used engine into my car for this summer just so I don't have to drive my pickup all summer because that would be depressing. Since GSL-SE six-ports are a bit scarce I was wondering about using a 2d gen short block. I've been getting conflicting information about this. I think it's established that by using my oil pan and front cover, the engine will bolt right in and manifolds bolt right on. What seems to be a point of contention is the injectors. Do the 2d gen engines have the holes in the centre iron for my injectors? I don't want to switch to a 2d gen intake and computer.
Cheers
J
Cheers
J
#5
Originally Posted by DJ Rotor' date='Mar 23 2004, 11:46 AM
I don't want to switch to a 2d gen intake and computer.
--------------------------
Well then looks like its time to go shopping!
Thread
Thread Starter
Forum
Replies
Last Post
TweakGames
Rotary Engine Building, Porting & Swaps
25
10-14-2007 12:10 AM
Rxcalibur
1st Generation Specific
16
05-17-2005 05:00 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)