NEED HELP clutch master and slave cylinders
#1
i need help my car is stuck at school
its an 81 12a
i bled my clutch and yet no results clutch willnot disengage
so i figuered it was my master or slave
so i was wondering if anyone can help me on the steps on the proper way to remove and reinstall a new master and slave cylinders
thanks all your help is well appreciated
its an 81 12a
i bled my clutch and yet no results clutch willnot disengage
so i figuered it was my master or slave
so i was wondering if anyone can help me on the steps on the proper way to remove and reinstall a new master and slave cylinders
thanks all your help is well appreciated
#4
i had to replace my slave cylender and clutch master cyl. on my 86' FC. basically just remove/replace. no hard steps. should just unbolt/bolt right back on... it will take some fighting cuase i know there both in tight spots. well on mine anyway. dont worry about "bench bleeding" the clutch master cyl. like the instructions say... mine is fine and works great
#5
I would bench bleed if you have a vice and some extra rubber hose. it makes the install much easier. I would also clean the new parts, because there could be debre from machining them. and be gentle when you first pump the clutch so you dont jam the return spring.
Thread
Thread Starter
Forum
Replies
Last Post
arkadyzv
RX-7 & RX-8 Parts For Sale & Wanted
1
03-23-2007 03:43 PM
CharlieDontSurf
RX-7 & RX-8 Parts For Sale & Wanted
0
08-04-2003 12:03 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)