Racer X

I noticed the shifter rod is hollow.What did you guys use to seal the end off with?Would JB weld work or does it need to be a really strong bond to it?Do I fill the shifter housing with fluid before I install my tranny aswell too?Sorry about all the questions.First time doing the full out swap.



Luis

j9fd3s

the hollow tube is there to seal up the shifter box. you can silicon seal the end. there should be a shift rod going in there thats not hollow



mike

setzep

I sectioned out the tube, (aka took out a chunk of the center ) This way it still had the stoock rubber seals on the end. Or you can just use some kind of silicone to seal it off.

Racer X

So I have to seperately fill the box with fluid then?

j9fd3s

yup, before you put the shifter in you fill it with oil, no big whoop



mike

setzep

So why is there 2 different fill plugs and 2 different drains on the T2 box? Do I need to fill them both or what?

j9fd3s

you fill one until the other is full. it doesnt make a lot of sense though



mike