Scrub

I just got done painting mine. I will post pics as soon as I put em on my computer. I used some kit from a local import shop.

Rob x-7

use brake cleaner, no need for simple green or water.



eastwood sells a nice self leveling paint you brush on



brush on=no masking or overspray

MazdaMike

but if u spray u can do several thin layers and it will last longer. u can do layers with brushing but a lot less it might wind up shipping sooner

twyatt

Ok, I have found 2 types of high heat auto paint. One says it is good up to 500degrees. The other is good to 1200 degrees. Is the 500 degree good enough? (That has a better color selection)

Rob x-7

the product is sold by eastwood



they only sell the highest quality products, im sure its a good product



not too mention the key thing about it- its a 2 part paint that

relies on a chemical curing process, versus aerosol products that

technically never fully cure as they rely on air only.



I will always go for a chemical cure.

Sinful7

But for someone that's interested in a 'Hey, I'm bored' job, the 500 deg Hi-temp paint works great.

And yes, I used a high-temp clearcoat.

Rob noted that water and simple green are not necessary, but I found that the additional scrubbing actually lifted some

more grime from the painting surface.

MazdaMike said to use a 'metal file' to expose the Mazda logo in bare metal, I think that may be a bit agressive -

stick to sandpaper. You wouldn't want to over-file the corners of the raised logo or anything. If it's going too slow, plug in

the orbital sander or use a low grit paper. You can put some strips of masking tape around the Mazda logo to protect the

caliper, then just be careful not to burn through them with the sanding. If you move from a coarse paper to a finer

paper, you should be able to achieve a shiny finish. I decided that a chrome-polish was not necessary, and left the logo

a little rough - it has a brushed look now. Clear coat the whole thing to prevent rust and facilitate cleaning and you're done!



Oh, and just a note - try to avoid spraying the interior of the

caliper, especially the piston seals. While the parts are fairly durable, they can be damaged and then would require rebuilding.

FiKsE l2X SeVeN Jr

i'm planning on painting fikse's calipers.....what color will go better, blue or black?

Sinful7

The blue won't even be close to matching - I liked the black look. They don't stand out, but when people notice them (especially with the polished raised MAZDA logo), they're always saying 'Hey, Look at that!'

Better than a stand-out part, in my opinion.

FiKsE l2X SeVeN Jr

damn ur persuasive...... black it is

Redwood

I recommend hitting the calipers with a wire brush, preferrably attached to a drill. Not too necessary with new calipers but for older calipers it's invaluable. I did that and ended up just clear coating them because the polished metal looked so good.



Also, I'll second the chemical cure thing. Aerosol...ugh.



Redwood