I figure I'll make a thread covering the installation of my cosmo 2 rotor motor to replace the s5 j-spec motor, that replaced my s4 stock turbo motor with 200k+ miles on it. Only the cosmo information will be covered here tho, I have an old thread titled "engine swap minus the bullshit" that covered the initial swap and installation of the wolf 3d, ignitor, coils, fmic, ect.



First of all a big thank you to jr from Just Racing Fabrications, for the mounts, plumbing modifications, some brackets, porting the manifolds, and letting me pick his brain for some ideas about this swap.



Ok some pics to preface the swap

 

Pics of throttle body before and after, ported, and modified by jr.

 

Jr assured me he would be able to cut the restricitons out of the exhaust sleeves with the motor in tact. He explained his procedure to me and it makes perfect sense, but I don't think I'll give away all his secrets! This is before he filled the sleeve back in with some stainless.



half done

 

he's too cheap to use block off plates, so he just does this instead! Tree huggers don't look!

 

both sleeves done now, awaiting a manifold!

 

long block prettied up!

 

rear view loads of room under there

 

and what you've all been waiting for



to4r, for that ***

 

jump forward in time a couple more days, and this is what the monster is becoming



doesn't seems so off balanced now

 

i was worried about that big bitch radiating heat on the fuel lines just above, so i come in one day and jr had made a shield for it! looks like it means business