Got my 62-1 on last sunday and have had lots of oil seeping out of the Center Cartridge. I was told by Igy that it's because the hole in the restrictor plate for the oil inlet is too big.



My question is....



WHAT SIZE HOLE SHOULD I BE DRILLING THEN?

 

as long as we are on this topic, i want to make my own oil return line instead of the stock on with alll those vac lines on it, what size should it be?

 

Technically thats the supply line.



I'm poor, so I just cut the vacuum line off mine at the spot welds or whatever they are.

 

ok so on the feed line what size should i use? and just stick a 90degree an fitting in there, but what about the other end? I know u guys aren't using the stock stuff...

 

Van, I drilled my new one to 1.8mm and it's working great...