I just bought a turbo and motor!!!

Reply Subscribe

Thread Tools

Search this Thread

11-21-2002, 04:51 PM

#31

Felix Wankel

Senior Member

Join Date: Nov 2001

Posts: 664

Measure the diameter of it at the bottom (bottom= near the backplate) of the wheel where the blades stop.

11-21-2002, 09:31 PM

#32

1Revvin7

Senior Member

Thread Starter

Join Date: Oct 2001

Location: Peoria, AZ

Posts: 10,906

Quote:

Originally Posted by Felix Wankel' date='Nov 21 2002, 05:51 PM

Measure the diameter of it at the bottom (bottom= near the backplate) of the wheel where the blades stop.

ah, thank you, much clearer!! You are used to turbo newbs ic...

I will go now and get those damn measurements!!

11-21-2002, 09:49 PM

#33

Felix Wankel

Senior Member

Join Date: Nov 2001

Posts: 664

I was a turbo newb many moons ago!

Nowadays I am slightly less of a newb.

11-22-2002, 12:51 AM

#34

1Revvin7

Senior Member

Thread Starter

Join Date: Oct 2001

Location: Peoria, AZ

Posts: 10,906

It is 3 inches.

11-22-2002, 02:59 AM

#35

jspecracer7

Senior Member

Join Date: May 2002

Location: Okinawa, Japan

Posts: 4,928

Okay, now here's the question...How do you have a turbine blade with a 3" inducer and a 3" excuder?

Where the blade start at the top is the inducer. Measure the diameter of the top. The exducer is the bottom of the wheel...the part that seats next to the back plate. The compressor housing is the part that is attached to the back plate. The exducer will be LARGER than the inducer. Try to get it EXACTLY measured so we can tell what type of hybrid it is!

11-22-2002, 10:34 AM

#36

1Revvin7

Senior Member

Thread Starter

Join Date: Oct 2001

Location: Peoria, AZ

Posts: 10,906

ok, now that makes sense. Ok i will go measure the inducer then, but the exducer is 3 inches.

11-22-2002, 12:24 PM

#37

1Revvin7

Senior Member

Thread Starter

Join Date: Oct 2001

Location: Peoria, AZ

Posts: 10,906

well i got 2" 4/16s for the inducer. Hard to tell but i re measured several times

11-22-2002, 03:27 PM

#38

jspecracer7

Senior Member

Join Date: May 2002

Location: Okinawa, Japan

Posts: 4,928

Okay, I'm determining this by the the turbonetics 2000 catalog so bear with me.

It's possible that you have a t-04E-57t or 60t. 57t measures 2.23" inducer, with the exducer measuring 2.95". The 60t measures 2.29" with the exducer measuring 2.95".

If it really is a 3" exducer, then you may have either a super V or H trim which would make it a t-04B...but dont' quote me on this(someone chime in to help me out if I'm wrong".