I've trying to figure out what to tell the tuner as far as setting things up...









This one had the floor dropped down about another .5 inch after the pic was taken.







Any help would be great

Thanks

~Luke

 

just tell him mild streetport.

doesn't look like the intake port timing was advanced very much (if any)



those rotor housings look pretty beat down.. can you clean them up a bit more and get some more pics?

 

Did you bevel the closing edge of the exhaust ports?

 

Judging by the metal shavings all over the housing, it looks like this photo was taken mid way through porting.



THose housings have some pretty bad chatter marks and it looks like some pretty deep gouges above the exhaust port. I don't think I'd use them.

 

Those were some old housings i was messing around with. Yes i beveled down the top edge. IT was also during mid trial porting.