rotary speedster

Well, I am contemplating on selling my Rx7. Im getting out of the

military in about 9 months and would like to pay some bills off. Here

is a description of the car.



93 Rx7 Vintage Red Touring model 5spd 96k mi on the chassis

The engine has around 11k mi on it including a 1,400 mi trip to

West Palm beach. Replaced all parts that where not within spec, including new

rotor housings and a new front plate. I just had the turbos rebuilt and haven't even boosted them yet. The wastegate has been ported to help control the boost, and the are still under warranty with BNRsupercars.



MODS

-Small street port

-All emission stuff removed and blocked off

-Turbos are setup full non sequential

-ACT steet/strip clutch

-What vacum lines are left are silicone

-Haltech E6K EMS

-Greddy Profec B boost controller

-Greddy Stock mount intercooler

-Apex intakes

-Pettit downpipe and midpipe

-HKS Catback exhaust

-Greddy alternator and water pump pulleys

-Supra TT fuel pump

-Injectors cleaned and balanced by RC engineering

-Autometer boost, water, and oil pressure gauges

-99 R1 front spoiler lip

-Wheels are painted black with a clear coat



I have also replaced tons small parts that are prone to failure and

have the receipts for almost everything. Took it to Pettit to have it tuned. I asked for very conservative timing and fuel, as I could not afford another

rebuild. It made 290rwhp at only 11psi in 3rd gear with the stock clutch slipping. I am convinced that it is 300+rwhp with the upgraded clutch and capable of much more with more agressive tuning and more boost. I have not drove the car much since the motor rebuild. I have a R1 rear spoiler that will go with the car.



Minor problems: The 5th gear synchro is bad. So it does not have 5th or reverse. There are 8 bolt holes in the rear hatch from a previous wing. This should only cost a couple hundred bucks to get repaired and painted. The front left

wheel has a scuff in the paint from the dyno strap. I can't seem to get the speedo or the dash lights working after installing the Haltech.



Milton, FL right by Pensacola. As for the price, Im asking $12,900obo. I have put about that much into the car in mods and rebuild alone. And yes I will have another FD one day.

rotary speedster

rotary speedster

A few pics, I know its dirty.

rotary speedster

Crap. Can a mod move this to the cars forsale forum. Sorry.