WTB: A/C lines for FC
#1
Senior Member
Thread Starter
Join Date: Nov 2003
Location: Hell (Colorado School of Mines)
Posts: 521
Hopefully not everyone has trashed their A/C stuff entirely. Since my FC is my DD, it would be nice to have A/C in it. I tried to do the full precedure to recharge the A/C but the system wouldnt pull down to vacuum. I found out that the high-side line in the engine bay has a hole in it under the air filter. Also, the low side service port seems to have a bad valve.
I am looking for the high- and low-side hard lines in the engine bay, preferably from a lowish mileage car. The body I have has over 225,000 miles on it so some of the other parts may be in bad shape. A good condition receiver/drier would be nice too.
Thanks
Andy
I am looking for the high- and low-side hard lines in the engine bay, preferably from a lowish mileage car. The body I have has over 225,000 miles on it so some of the other parts may be in bad shape. A good condition receiver/drier would be nice too.
Thanks
Andy
#3
Here's what I was able to find after digging through a few boxes. If you want any (or all) of this stuff, make me a reasonable offer. I don't need anymore than enough to cover shipping and something to compensate me for the time it would take me to stuff it in a box and drop it at the PO.
I would advise against using a used receiver/drier. Once they're open to atmosphere, they're useless.
These items are from one of two different S4 T2's. Neither one had more than 115k on the chassis. The lines will need to be blown out, since they've been sitting in a box for a couple years now.
Let me know via PM.
I would advise against using a used receiver/drier. Once they're open to atmosphere, they're useless.
These items are from one of two different S4 T2's. Neither one had more than 115k on the chassis. The lines will need to be blown out, since they've been sitting in a box for a couple years now.
Let me know via PM.
Thread
Thread Starter
Forum
Replies
Last Post
1Revvin7
2nd Generation Specific
0
11-06-2002 07:40 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)