Im looking for a FD Engine and Transmission.
I would really really prefer to get a complete pull or drop out. Im putting this in my MX and would like to have EVERYTHING I need for the swap rather than have to get misc little parts here and there. I am considering Blown motors and trans as well. Reason why is I need to do my measurements and cut/welds SOON. And with putting in a bad engine and trans...at least its in there and I can either get a good drivetrain or fix the bad. Anyway, complete swaps are prefered...Engine and Trans dont have to be together though... but again...would prefer that they are. I would appreciate any help guys on location one https://www.nopistons.com/forums/pub...IR#>/smile.gif Im located in 48103 |
The pic you posted isnt an FD motor. Its a Eunos/Mazda Cosmo 13b RE with its automatic trans.
Check JDM importers for engines and trans. Or even a whole front clip. |
Originally Posted by RONIN FC' post='885777' date='Oct 18 2007, 08:55 PM
The pic you posted isnt an FD motor. Its a Eunos/Mazda Cosmo 13b RE with its automatic trans.
Check JDM importers for engines and trans. Or even a whole front clip. Im aware I posted a Cosmo motor. It was used for...well...comparative purposes. Im just trying to tell ppl that I am looking for something like that. Complete. Not a shortblock, not just the rotor housings, etc Ive checked with a few importers and stuff but would rather deal with a US spec for costs. A stock US spec FD should be a little cheaper than a Jspec FD, right? I would consider the front clip...but dont want to spend the 2500+ on a clip just to use the engine, trans and ecu and then have to sit and try and sell the rest of the stuff. https://www.nopistons.com/forums/pub...DIR#>/ohmy.gif |
Originally Posted by Blazianenigma' post='885781' date='Oct 18 2007, 06:25 PM
Im aware I posted a Cosmo motor.
It was used for...well...comparative purposes. Im just trying to tell ppl that I am looking for something like that. Complete. Not a shortblock, not just the rotor housings, etc Ive checked with a few importers and stuff but would rather deal with a US spec for costs. A stock US spec FD should be a little cheaper than a Jspec FD, right? I would consider the front clip...but dont want to spend the 2500+ on a clip just to use the engine, trans and ecu and then have to sit and try and sell the rest of the stuff. https://www.nopistons.com/forums/pub...DIR#>/ohmy.gif I've got a complete swap sitting in my garage...I was going to throw it into my FC - But it is Jspec. So.. its your call. |
bump....
Still looking for a FD 13B Full transplant Engine. I need all components...since this is not going into a RX7 |
All times are GMT -5. The time now is 01:07 PM. |
© 2024 MH Sub I, LLC dba Internet Brands